Samsung RSG5 User Manual
1_
setting up
4. Remove the filter cap and insert the
filter into the filter housing.
5. Slowly turn the water filter 90º
clockwise to align with the printing
mark on the cover, locking the filter
in position. Make sure to align the
water filter label mark with center
of cover filter printing as illustrated.
Remember, do not over-tighten.
mark on the cover, locking the filter
in position. Make sure to align the
water filter label mark with center
of cover filter printing as illustrated.
Remember, do not over-tighten.
Removing any residual matter inside the water
supply line after installing filter.
supply line after installing filter.
1. Turn ON the main water supply.
. Press the Water button and push the dispenser pad.
. Run water through the dispenser until the water runs clear
. Press the Water button and push the dispenser pad.
. Run water through the dispenser until the water runs clear
(approx. 3L). This will clean the water supply system and
remove air from the lines.
remove air from the lines.
. Additional flushing may be required in some households.
. Open the refrigerator door and make sure there are no water
. Open the refrigerator door and make sure there are no water
leaks coming from the water filter.
A newly installed water filter cartridge may cause water to
briefly spurt from the water dispenser. This is due to air
getting into the line. It should pose no problem to operation.
briefly spurt from the water dispenser. This is due to air
getting into the line. It should pose no problem to operation.
Check the amount of water supplied to the ice tray.
1. Lift up the icemaker cover and gently pull out.
. When you press the Test button for 3 seconds, the ice cube container is filled with water
. When you press the Test button for 3 seconds, the ice cube container is filled with water
from the water supply tap. Check to make sure the amount of water is correct(see the
illustration below).
If the water level is too low, the ice cubes will be small. This is a water pressure problem from
with in the main water pipes, not the refrigerator.
illustration below).
If the water level is too low, the ice cubes will be small. This is a water pressure problem from
with in the main water pipes, not the refrigerator.
- It will take a few minutes to reach the amount of water you want.
- Do not press the test button continuously when the tray is filled with ice or water as
- Do not press the test button continuously when the tray is filled with ice or water as
illustration below. Water may overflow or ice jamming may occur.
- When the bucket is not installed, the ice maker does not work.
- When ICE OFF blinks on the display panel, reinsert the bucket and/or make sure it’s
- When ICE OFF blinks on the display panel, reinsert the bucket and/or make sure it’s
installed properly.
Cover filter
align the indication
mark with lock position
separation
of red cap
ice maker
1
test button
Check the water level
CAUTION
water
ice
DA99-01745A(EN)-GGH-0.3.indd 18
2008.8.20 8:42:4 PM