Smeg 142306 User Manual

   

142306

Instructions for Use

50

During the service, you can come across some
troubles that in most cases result from improper
handling of the appliance and can easy be
eliminated.

•  Check the supply in the outlet socket and make

sure the appliance is switched on (thermostat
knob in operating position).

•  The door was frequently opened or it was left

opened for too long.

•  The door is not properly closed (the door may

sag, the gasket may be polluted or damaged).

•  Perhaps you have overloaded the appliance

with fresh foods.

•  The reason may be inadequate ventilation of

the compressor and condenser (assure
adequate air circulation and wipe off the
condenser).

As long as the defrost water runs to the channel
and through the outlet to the drain pan on the
compressor, automatic defrosting of the
appliance is assured.
In case the ice formation on the inner back wall is
increased (3-5 mm), ice should be manually
defrosted.
Set the thermostat knob to STOP (0) position and
leave the door open. Never use electric devices
for defrosting and do not scrape the ice or frost
layer with sharp objects.
After completed defrosting, turn the knob to
desired position and close the refrigerator door.
The cause of increased ice formation may be one
of the following:
− the door does not seal well (clean the gasket if

it is contaminated, or replace it if it is damaged);

− the door was frequently opened or it was left

opened for too long;

− the food stored in the refrigerator was warm;

− the food or dish is touching the inner back wall.

In case the discharge water outlet is clogged, or
the defrost water drips over the channel, water
leaks from the refrigerator.
•  Clean the clogged outlet, for example with a

plastic straw.

•  Manually defrost the increased ice layer. See

"Ice Formation on the Inner Rear Wall".

Cooling in refrigerating-freezing appliances is
enabled by the cooling system with compressor,
which produces noise. How noisy the appliance is
depends on where it is placed, how it is used and
how old the appliance is.
•  During the operation of the compressor the

noise of liquid is heard and when the
compressor is not operating, the refrigerant flow
is heard. This is a normal condition and it has
no influence whatsoever on the lifetime of the
appliance.

•  After starting the appliance, the operation of

the compressor and the refrigerant flow may be
louder, which does not mean that something is
wrong with the appliance and it has no
influence on the lifetime of the appliance.
Gradually the noise is reduced.

•  Sometimes unusual and stronger noise is

heard, which is rather unusual for the
appliance. This noise is often a consequence of
inadequate placing.
− The appliance shall be placed and levelled

firmly on solid base.

− It should not touch the wall or kitchen units

standing next to it.

− Check the accesories in the interior of the

appliance, they should be placed correctly in
their positions; also check the bottles, tins
and other vessels that might touch each other
and rattle.