Gigaset AL140 Duo L36852-H2001-M101 User Manual

L1a / GBR / A31008-M2001-L101-1-7619 / AL140_AL145_Kombi_GBR.fm / 12.09.2008

Closing the battery cover 
Place the cover on the battery compartment as 

shown in the diagram, then push it up until it clicks 

into position.

Opening the battery cover
Press down on the battery cover below its upper 

end and slide the cover down.

Precondition: The handset must not already be 

registered to a base station. 
The handset is automatically registered to the 

Gigaset A140/AL145 base station. Place the hand-

set in the charging cradle of the base station with 

its display facing forward. You will hear a confir-

mation tone. Leave the handset in the base station 

until it is registered.
Automatic registration can take up to 5 minutes. 

While this is happening, Registering flashes in the 

screen. The handset is assigned the lowest unas-

signed internal number (1–4). If several handsets 

are registered on the base station, the internal 

number is shown in the top left of the display after 

registration, e.g. 2. If the internal numbers 1 to 4 

have already been assigned (four handsets have 

already been registered), handset number four is 

deregistered and overwritten.

To charge the battery pack, leave the handset in 

the base station for approx. 7 hours. The battery 

pack is now fully charged. The charge status of the 

battery pack is only correctly displayed after unin-

terrupted charging/discharging. Therefore you 

should not interrupt the charging process.
Charging is electronically controlled to prevent 

overcharging. The battery pack heats up during 

charging. This is normal and not dangerous. 

After a time its charge capacity will decrease for 

technical reasons. 
You must set the date and time to ensure that the 

times of calls are logged correctly (see Menu tree 

page 11). 
Once the phone is registered and the time set, the 

idle display looks as shown on page 1.
If you have any questions about using your phone, 

please read the tips on troubleshooting ("Ques-

tions and answers", page 9) or contact our cus-

tomer service department (page 10).

External calls are calls using the public telephone 

network.

~ 

(Enter the phone number) 

¢

c

. 

The number is dialled. (Or you can first press and 

hold 

c

 [dial tone] and then enter the number.) 

During the call you can adjust the earpiece volume 

using 

t

.

End the call/cancel dialling: 

Press the end call key 

a

.

You can automatically insert a network provider 

dialling code before any phone number (see 

"Preselection" Menu tree, page 11).

The handset indicates an incoming call by ringing 

and by a display on the screen.
Press the talk key 

c

 to answer the call.

When Auto Answer is activated (see Menu tree, 

page 11), simply remove the handset from the 

base station/charging cradle.

When you get a call, the caller's number will be dis-

played on your handset; the caller's name will be 

displayed if it is stored in the directory.
Preconditions: 
1 You have asked your network provider for the 

caller's number (CLIP) to be displayed on your 

handset screen.

Please note:
If you have acquired additional handsets in this 

Gigaset family or other Gigaset handsets, each 

handset must be registered to your base station in 

order for them to work properly, see also page 6!