Shindaiwa X7501970601 User Manual

8

Blower tube installation affects blower 

performance! Make sure the tubes and 

nozzle are correctly assembled per 

above, and that all connections are 

tight. Blower tubes may come apart dur-

ing use unless tubes are aligned and 

locked into place. 

Place the blower upright on the 

1. 

ground or a sturdy work surface and 

note parts orientation as shown in 

Figure 7.
Remove static wire from package 

2. 

and fix eyelet to right hand engine 

cover screw. See Figure 8.
Turn the discharge tube out to a 

3. 

right angle and slip anti-static wire 

through the 102mm clamp and flex-

ible tube.
Install throttle cable holder just for-

4. 

ward of the 102 mm clamp, pinching 

loops together to fit over end of flex-

ible tube. See Figures 10A and 10B.
Slip the flexible tube over the end of 

5. 

the 90° discharge tube, and secure 

with the 102 mm clamp.
Slide the throttle assembly over the 

6. 

swivel tube. Do not tighten clamp at 

this time.

Insert the static wire through the 

7. 

swivel tube, then install and tighten 

the 89mm clamp over the rotating 

band on the swivel tube.
Fold the end of the static wire back 

8. 

over the connection of the swivel 

tube. See Figure 8. 
Grasp the straight tube, and push 

9. 

the straight tube over the swivel 

tube locking pins securing the static 

wire. See Figure 9.
Lock the straight tube to the swivel 

10. 

tube by rotating the straight tube 

noting the alignment marks. See 

Figure 9.
Grasp the nozzle, and push the 

11. 

nozzle over the straight tube locking 

pins.  See Figure 9.
Lock the nozzle to the straight tube 

12. 

by rotating the nozzle noting the 

alignment marks.  See Figure 9. 

Stop the engine before installing or 

removing the blower tubes! Never 

perform any maintenance or assem-

bly procedures on this unit while the 

engine is running! 

This unit is equipped with a static 

discharge reduction wire. This wire 

helps direct static buildup into the air 

stream reducing the felt amount to the 

operator. 

Check to make sure that the 90° dis-

charge tube swivels freely. If any 

binding is present, loosen 102 mm 

clamp and pull wire towards engine to 

get more slack and recheck for free 

movement.

Adjust throttle assembly for best 

13. 

operator comfort, and tighten two 

socket-head screws securely.

Optional           

Long Nozzle 

(ø74 mm)