Crosley 2209920 User Manual

Page of 16
4
INSTALLING YOUR 
REFRIGERATOR
Unpacking Your Refrigerator
Remove shelves from the shipping position (shelves are 
shipped upside down):
IMPORTANT:
 Do not clean glass shelves with warm water when 
they are cold. Shelves may break if exposed to sudden 
temperature changes or impact, such as bumping. For your 
protection, tempered glass is designed to shatter into many small 
pebble-size pieces. This is normal. 
NOTE:
 Glass shelves are heavy. Use special care when removing 
them to avoid impact from dropping.
1.
Grasp the front of the upper shelf with one hand and use the 
other hand to remove packing material from the shelf area.
2.
Lower the front of the upper shelf until shelf hooks can be 
removed from the shelf supports and pull the shelf forward. 
3.
Flip the shelf over and insert the rear shelf hooks into the 
shelf supports. Tilt the front of shelf up until rear shelf hooks 
drop into the shelf supports.
4.
Lower the front of the shelf and check to make sure that it is 
securely in position.
Removing packaging materials
Remove tape and any labels from your refrigerator before 
using (except the model and serial number label).
To remove any remaining tape or glue, rub the area briskly 
with your thumb. Tape or glue residue can also be easily 
removed by rubbing a small amount of liquid dish soap over 
the adhesive with your fingers. Wipe with warm water and 
dry.
Do not use sharp instruments, rubbing alcohol, flammable 
fluids, or abrasive cleaners to remove tape or glue. These 
products can damage the surface of your refrigerator. For 
more information, see “Refrigerator Safety” section.
On some models, shelves, bins, door shelf rails, and other 
feature parts may be packaged in the Interior FeaturePak. 
Follow the instructions contained in the package for proper 
assembly.
IMPORTANT: 
Depending on your model, do not remove any permanent 
instruction labels inside your refrigerator or the Tech Sheet 
that is fastened behind the base grille. 
Depending on your model, do not remove the white 
Styrofoam insert that is located behind the control panel on 
the ceiling of the refrigerator. The insert is part of the 
refrigerator and not part of the packing material. If the insert 
is removed, ice may migrate down from the freezer and cause 
icicles to form.
WARNING
Excessive Weight Hazard
Use two or more people to move and install 
refrigerator.
Failure to do so can result in back or other injury.
When Moving Your Refrigerator:
Your refrigerator is heavy. When moving the refrigerator 
for cleaning or service, be sure to protect the floor. 
Always pull the refrigerator straight out when moving it. 
Do not wiggle or “walk” the refrigerator when trying to move 
it, as floor damage could occur.