Emerson XDCF User Manual

The upper Liebert XDCF module attaches to the Egenera BladeFrame cabinet with a mounting angle 

and four bolts.
Before the Liebert XDCF is mounted, the mounting angle and a two-piece deflector panel must be 

attached to the bottom of the Liebert XDCF and insulation must be applied to the left side.

1. Position the mounting angle over the two mounting holes. The holes are near the center of the 

bottom of the Liebert XDCF module (see Figure 7).

2. Use two captive panel fasteners to attach the mounting angle to the bottom of the Liebert XDCF 

module. Tighten the fasteners securely, using a screwdriver, either a blade-type or Phillips.

3. Position the bottom deflector over the two mounting holes along the front edge of the bottom of 

the upper Liebert XDCF module (see Figure 10). The flanges along the edge should be on the top 

side.

4. Use two captive panel fasteners to attach the bottom deflector to the bottom of the upper Liebert 

XDCF module. Tighten the fasteners securely with a screwdriver, either a Phillips or a blade-

type.

5. Position the second piece of the bottom deflector along the front edge of the deflector piece 

attached in Steps 3 and 4, matching the mounting slots in the two pieces. The flanges along the 

edge should be on the top side.

6. Use two captive panel fasteners to connect the deflector pieces. Tighten the fasteners finger-tight, 

leaving them loose enough to slide for good contact with the Egenera BladeFrame cabinet.

Coil

Bottom
Deflector
Bracket

Gasket not shown
for clarity

TOP VIEW

7-5/16"

(186mm)

1-7/16"

(37mm)

3-9/16"

(90mm)

Pipe support brackets
not shown for clarity

1-7/16" 

(37mm) 

3-9/16" 

(90mm) 

Mounting
Angle