Electrolux EI23BC51IS Use & Care Manual

To level the cabinet using the front rollers:
     1   Slightly open freezer drawer.  Lift the toe grille 

and gently pull forward (see illustration).

     2  You can raise or lower each door.  Use a ³⁄₈ inch 

socket wrench to turn the adjustment screws (1 
per side).

  

          To raise:  turn adjustment screw clockwise.
 

  To lower:  turn adjustment screw 

counterclockwise.

 

3  Ensure both doors are bind-free with their seals 

touching the cabinet on all four sides and that 
cabinet is stable.

 

4  After unit is leveled, lower anti-tip leg until it

contacts the floor.

 
 

Anti-tip

Leg

Door

Door

 

1  Check gasket seal around top, bottom, and sides 

of freezer drawer.

 

2  If gasket is not sealed, open drawer and slightly 

loosen four (4) drawer screws (two (2) on each 
side) to allow drawer to rotate.

 

3  Close drawer and recheck the seal on the gasket 

(A). Open the drawer grabbing by the sides in the
center (B).  Be careful not to rotate the drawer.

Remove Hex

Head Drawer

Screw

Remove Hex

Head Drawer

Screw

Do Not Remove

Other Screws

Remove Hex

Head Drawer

Screw

Remove Hex

Head Drawer

Screw

Do Not Remove

Other Screws

 

4  Tighten four (4) drawer screws.

 

5  Recheck gasket seal.

Pull Drawer Out

From Both Sides

Grab Drawer

At Center

Then

Push Against

Freezer Drawer

 

5  Install the toe grille by fitting into place.

 •  All four corners of the cabinet must rest firmly on

the floor.

 •  The sides should tilt

1

/

4

 inch (6 mm) from front 

to back (to ensure that doors close and seal 
properly).

 •  Doors should align with each other and be level.