Delfield 402 Leaflet

Exterior top shall be one-piece, 22-gauge stainless steel with front edge turned down 

to form nosing and rear edge turned up to form a 2" (5.1 cm) thick by 4" (10.2 cm) 

high backsplash.

Exterior back and bottom shall be one-piece 24-gauge galvanized metal. Exterior 

ends shall be 22-gauge stainless steel.

Base interior shall be one-piece thermoformed ABS plastic material, with integral 

shelf supports. Base shall be fully insulated with high-density foamed-in-place poly-

urethane.

Doors shall have a 22-gauge stainless steel exterior, with a thermoformed ABS plas-

tic interior liner, and shall be fully insulated with foamed-in-place polyurethane. Door 

handles shall be black, recessed and shall extend the full length of the top of the door. 

Cabinet shall have (2) adjustable epoxy-coated wire shelves installed. 

Refrigeration system shall use HFC-404A refrigerant. Compressor shall be å h.p., 

with condenser coil and hot gas condensate evaporator mounted on rear of cabinet. 

Evaporator coil and temperature control shall be mounted on the interior rear wall 

of the cabinet. Refrigerant flow shall be controlled by a capillary tube. Cabinet shall 

maintain 36°F to 40°F (2°C to 4°C) interior cabinet temperature.

Electrical connections shall be 115 volt, 60 Hertz, single phase. Unit shall have a 7' 

(2.1 m) long electrical cord and NEMA 5-15P plug. Cord and plug shall be located on 

rear of cabinet, centered left to right, 16" (40.6 cm) above floor.

Stainless steel back

Plastic laminate on front

Additional wire shelves

Stainless steel single-tier overshelf

3.5" (8.9 cm) diameter casters

5" (12.7 cm) diameter casters

Door lock

Full-size composite-type cutting top

220 volt, 50 Hertz electrical system

®

Delfield reserves the right to make changes in design or specifications without prior notice. ©2002 The Delfield Company. All rights reserved. Printed in U.S.A.