Delfield 18600VD User Manual

Delfield ·  980 S. Isabella Road, Mt. Pleasant, MI 48858 ·  (989) 773-7981 or (800) 733-8829 ·  Fax (989) 773-3210 

Gaskets require regular cleaning to prevent mold and 
mildew build up and also to keep the elasticity of the 
gasket. Gasket cleaning can be done with the use of 
warm soapy water. Avoid full strength cleaning products 
on gaskets as this can cause them to become brittle 
and prevent proper seals. Also, never use sharp tools 
or knives to scrape or clean the gasket, which could 
possibly tear the gasket and rip the bellows.

Gaskets can easily be replaced and do not require the 
use of tools or authorized service persons. They can be 
pulled out of the groove in the door and new gaskets 
can be pressed back into place.

The drawer assembly is designed to be cleaned 
easily. Both drawer and tracks are removable without 
tools. The drawer tracks are dishwasher safe or can 
be cleaned in a sink with detergents and a soft bristle 
brush. Drawers and tracks should be cleaned on a 
weekly basis.

Pull the drawer box out until it stops. Lift up on the 
drawer front and pull the drawer box completely out. 
Using a soft bristle brush, clean the track on the bottom 
of the drawer box. When finished, it should be wiped 
clean of all food and debris.

The drawer box assembly must be removed. Pull the 
drawer tracks out until they hit a stop. Locate blue 
safety clips towards the back of each drawer track. 
Blue safety clips have a tab on the top. Push the tab 
back until it clicks. Lift up and pull the drawer tracks all 

the way out of the 
drawer cage. The 
drawer tracks are 
dishwasher safe or 
can be cleaned in a 
sink with detergents 
and a soft bristle 
brush. Drawers and 

tracks should be cleaned on a weekly basis. Using a 
soft bristle brush, wash the track making sure each 
roller is thoroughly cleaned. The drawer cage should 
be cleaned with a soft bristle brush, removing any 
food and debris gathered on the bottom ledge. Once 
it’s cleaned thoroughly with a soft bristle brush, wipe 
remaining debris clean with a soft towel.

Push the drawer tracks into the drawer cage. The blue 
safety clip must remain pushed towards the back. 
Lift up and slide the drawer track all the way into the 
drawer cage. The blue safety clip will lock in place 
automatically. Once all tracks are replaced, insert the 
drawer box. Rest the drawer box bottom track on the 
front track roller. Then push the drawer back in place 
SLOWLY. When the drawer box is about half way in 
you will hit a STOP. You must lift the front of the drawer 
up approximately ½” (1.3cm) to continue inward. Clean 
tracks as often as possible. The cleaner the tracks are 
the better they will operate.