Liebherr 200514 User Manual

Switching off the IceMaker*
If no ice cubes are needed, the IceMaker can be switched off

independently of the freezer compartment.
When  the  IceMaker  is  switched  off,  the  IceMaker  drawer  can

also be used for freezing and storing food.

u

Press  the  On/Off  button  for  about  1  second  until  the  LED

goes out.

u

Clean the IceMaker.

w

This ensures that no water or ice remains in the IceMaker.

The NoFrost system automatically defrosts the appliance.
Refrigerator compartment:
The  defrost  water  evaporates  due  to  the  compressor  heat.

Drops of water on the rear wall are perfectly normal.

u

Regularly clean the drain opening to allow the water to flow

away (see 6.2) .

Freezer compartment:
The  moisture  condenses  on  the  evaporator,  is  periodically

defrosted and evaporates.

u

The appliance does not have to be manually defrosted.

Risk of injury and damage as a result of hot steam!

Hot steam can lead to burns and can damage the surfaces.

u

Do not use any steam cleaners!

Incorrect cleaning damages the appliance!

u

Do not use cleaning agents in concentrated form.

u

Do not use any scouring or abrasive sponges or steel wool.

u

Please  do  not  use  any  aggressive,  scouring,  sand-,

chloride-, chemical- or acid-based cleaning agents.

u

Do not use chemical solvents.

u

Do not damage or remove the type plate on the inside of the

appliance. It is important for the customer service.

u

Do  not  pull  off,  bend  or  damage  cables  or  other  compo-

nents.

u

Do not allow any cleaning water to enter the drain channel,

ventilation grille or electrical parts.

u

Please  use  soft  cleaning  cloths  and  a  universal  pH-neutral

cleaning agent.

u

Please use cleaning and care products suitable for contact

with foodstuffs in the appliance interior.

u

u

u

Clean  plastic  outer  and  inner  surfaces  with  lukewarm

water and a little washing-up liquid.

The  stainless  steel  doors  are  finished  with  a  high  quality

surface coating and must not be treated with the enclosed care

product,

as otherwise the surface coating will be damaged.

u

Please only use a soft clean cloth to wipe the coated door

surfaces. In the case of heavy soiling, use a little water or

neutral  cleaning  agent.  A  micro-fibre  cloth  can  be  used

optionally.

u

When  soiled,  clean  stainless  steel  side  walls  with  a

commercially available stainless steel cleaning agent. Then

apply the enclosed stainless steel care product evenly in the

direction of polishing.

u

Use  only  a  soft  clean  cloth  to  wipe  side  walls  and  door

surfaces with a paint finish. In the case of heavy soiling, use

a  little  water  or  neutral  cleaning  agent.  A  micro-fibre  cloth

can be used optionally.

u

Clean drain hole: Remove deposits

with  a  narrow  instrument,  e.g.  a

cotton bud.

u

Most  of  the  parts  can  be  dismantled  for  cleaning:  see  the

relevant chapter.

u

Clean  items  of  equipment  by  hand  with  lukewarm  water

and a little washing-up liquid.

u

Empty water collect tray: remove

water  tank.  Carefully  unlatch  tray

at  front  and  then  remove  from

below.*

*

u

Wipe dry the appliance and items of equipment.

u

Connect the appliance and switch it on again.

u

When the temperature is sufficiently cold:

u

Put the food back inside.

Fig. 16 

The IceMaker has to be switched on.

u

Pull out the drawer and remove the ice cubes.

u

Clean  the  drawer  with  warm  water  and  mild  washing-up

liquid.

u

When the drawer is pulled out, hold down the On/Off button

(about 10 seconds).

w

After about 1 s the LED goes out, the IceMaker is switched

off.

w

After about 10 s the LED flashes for about 60 s.

u

Slide in the drawer while the LED is flashing.

w

The ice-cube tray of the IceMaker turns to a skew position.