Bertazzoni X)486GPIRGI User Manual

 

27

Each surface burner of a Bertazzoni range is 
equipped with a thermocouple safety device. 

The thermocouple opens the flow of gas to the 
burner only when hot. Should the flame go off, 
the thermocouple will immediately close the gas 
flow to the burner eliminating any risk to your 
home. 

For faster activation of the thermocouple, always 
light the burners on maximum power. This will 
allow the thermocouple to reach the optimum 
temperature in the fastest time. 

To activate the electric ignition, simply turn the 
control knob counter‐clockwise to maximum 
power (

position). Press the knob to start the 

flow of gas and the ignition spark. The spark will 
released at the metal tip of the white ceramic pin 
located on the side of the burner. Once the flame 
is on, release the control knob gently. 

If the flame turns off, repeat the above 
procedure. 

The dual power‐burner is composed by two 
burners (inside and outside). Each burner is 
activated by a separate control knob. The two 
burners can be operated separately or together 
for maximum power. To activate the power‐
burner, turn on the central burner first, then turn 
on the external ring. 

ATTENTION: do not ignite burners if the black 
burner cap is not installed or not centred. The 
flame will be irregular.  

Manual ignition is always possible even when the 
power is cut off or in the event of power failure. 

Turn the control knob counter‐clockwise to the 
MAXIMUM position. Light the flame with a 
kitchen lighter or with a match. 

 

WARNING! 

1.  Always check that the burner caps are 

properly installed before operation. 
 

 

2.  Verify that the flame of the worktop burners 

is completely blue and with regular aspect as 
shown below. 
 

 

 

3.  Always adjust the burner flame so it does not 

extend beyond the edge of the pan.