KitchenAid 1860 User Manual

oVen conVersion

moDels 1860 & 1867

to convert oven Bake Burner

1. Access from left side as you are facing back of range.
2. Use a 1/2” combination wrench to turn the orifice

hood down snug onto pipe (about 2 to 2-1/2 turns).

IMPORTANT: Do not overtighten.

A. orifice hood
B. Pin
c. nAturAl GAs: increAse GAs – increAse flAme size (Preset

At fActory for nAturAl GAs)

d. lP GAs: decreAse GAs, decreAse flAme size.

to convert oven Broiler Burner

1. Remove oven racks.
2. Use a 1/2” combination wrench to turn the orifice

hood down snug onto the shoulder (about 2 to 2-1/2
turns).

IMPORTANT: Do not overtighten.
The oven broil burner flame cannot be properly adjusted
if this conversion is not made. See “Adjust Oven Broil
Burner Flame” section.

3. Complete installation. See “Make Gas Connection”

and “Electronic Ignition System” sections.

check operation of oven Broil Burner

1. Close the oven door.
2. Touch “Broil” and “Start”.
The oven burner should light within 8 seconds, under

certain conditions it may take the burner up to 50 to 60

seconds to light.

adjust oven Broil Burner flame (if needed)

Look through oven window to check broil burner for

proper flame. This flame should have a 1/2” (1.3 cm) long

inner cone of bluish-green, with an outer mantle of dark

blue, and should be clean and soft in character. No yellow

tips, blowing or lifting of flame should occur.

if flame needs to be adjusted:
1. Loosen the lock screw on the air shutter located at the

rear of the broil burner.

2. Adjust the air shutter as need.
3. Tighten lock screw.