Siemens C) User Manual

Installation

English 14

• A risk of tip-over may exist if the appliance is not installed in accordance with 
these instructions.

• If the range is pulled away from the wall for cleaning, service, or any other rea-
son, insure that the Anti-Tip Device is properly reengaged when the range is 
pushed back against the wall. In the event of abnormal usage (such as a person 
standing, sitting, or leaning on an open door), failure to take this precaution could 
result in tipping of the range. Personal injury might result from spilled hot liquids or 
from the range itself.

1. Adjust height of range and level by rotating the adjustable leg supports on the 

bottom of the range, using 1-1/4 inch (31.75 mm) wrench. See Figure 2: 
Adjusting the Leg Support. 

3. Measure to locate bracket position as shown in Figure 4: Anti-tip Bracket 

5. Secure bracket with 2 screws (not included) that are adequate for mounting 

surface. (i.e.; for wood floor use wood screws for concrete floor use concrete 
anchors and screws). 

1. Move range close enough to the opening to plug into the receptacle.
2. Slide range into position insuring that the left back leg slides under the anti-tip 

bracket. Range will sit 3/4” (19.05 mm) away from back wall when properly 
installed.

3. Carefully tip range forward to insure that the anti-tip bracket engages the 

range back brace and prevents tip-over.

4. Turn on electrical power. Check range for proper operation as described in 

Use and Care Manual. 

adjustable leg

wrench

drawer

flush against  
cabinet wall

floor

cabinet wall

rear wall

anti-tippin g
device

 9/16" (14.29 mm)
from rear wall to center of screw hole