Sennheiser EW 300 IEM G2 User Manual

49



Via the “

Sensitiv

” menu, adjust the transmitter’s input sensitivity (see

“Adjusting the sensitivity (transmitter only)” on page 64). 

To monitor the audio signal, connect headphones with a ¼” (6.3 mm) 
jack plug to the headphone output (PHONES) 



. 

Even short exposure to high volume levels will damage your hearing!
Set the volume for the connected headphones to the minimum before
putting the headphones on.



First, set the volume control 

!

 to the lowest volume by turning it to the

left as far as possible. Then gradually turn up the volume.

When people use headphones, they tend to choose a higher volume than
with  loudspeakers.  Listening  at  high  volume  levels  for  long  periods  can
lead to permanent hearing defects. Please protect your hearing,
Sennheiser headphones have an excellent sound quality even at low
volumes.

The service interface 



 is only required for servicing purposes.

For mounting one or two transmitters into a 19” rack, you require the GA 2
rack adapter (available as an accessory). The GA 2 rack adapter consists of:

y 2 rack mount “ears”

 "

y 1 connecting bar 

#

y 1 connecting plate 

$

y 2 covering plugs 

% 

for antenna holes

y 12 recessed head screws M 3x6
y 2 recessed head screws M 6x10

When mounting only one transmitter into a rack, you can use the AM 2
antenna mount (available as an accessory) to mount the transmitter’s
antenna connection to the front of the GA 2 rack adapter. The AM 2 antenna
mount consists of:

y 2 BNC extension cables (screw-in BNC socket 

&

 to BNC connector 

'

)

y 2 plains washers 
y 2 nuts

 

Neue Abbildung







#

$

%

"

'

&