Planar VS17.4SXAD User Manual
Installing the Display | 9
VS17.4SXAD / CM17.4SXAD
(
020-0168-00B
)
Connecting a Video Device
Use the following instructions if you are hooking up a camera, VCR, or
other S-Video or Composite Video device, and not using the VGA or DVI
input simultaneously. These instructions apply to S-Video and Composite
Video input-equipped displays only.
input simultaneously. These instructions apply to S-Video and Composite
Video input-equipped displays only.
1
Press the Power/Menu button until the Power ON indicator blinks.
After a moment, a No Signal Coming message appears.
2
Wait for the No Signal Coming message to disappear, approximately
3 to 5 seconds.
3 to 5 seconds.
3
Press the Power/Menu button to display the VGA
→ VIDEO menu.
4
Press the PLUS or MINUS ( / ) control to enter video mode.
5
Press the UP (
) arrow to change video modes if you are using
an alternate video source.
6
Press the PLUS or MINUS ( / ) control to select the desired
video mode.
video mode.
Connecting the Optional Touch Screen
If your VitalScreen CSR or VitalScreen CR display has the optional touch
screen, connect the display 9-pin D-sub serial port to the computer 9-pin
RS-232 serial port using the cable supplied with the touchscreen package.
Next, connect the RS-232 cable to the 9-pin serial port on the back panel
of the display.
screen, connect the display 9-pin D-sub serial port to the computer 9-pin
RS-232 serial port using the cable supplied with the touchscreen package.
Next, connect the RS-232 cable to the 9-pin serial port on the back panel
of the display.
Do not operate the touch screen with sharp objects, such as a scalpel.
Sharp objects can scratch or damage the touch screen. A damaged touch
screen may pose a safety hazard.
Sharp objects can scratch or damage the touch screen. A damaged touch
screen may pose a safety hazard.
Mounting the Display
When mounting your display, such as to a wall bracket or an
articulated swing arm, make sure the maximum length of the
screws inserted into the display mounts is 9 millimeters. Forcing
the screws deeper into the mounts and exceeding this maximum
length may damage the display.
articulated swing arm, make sure the maximum length of the
screws inserted into the display mounts is 9 millimeters. Forcing
the screws deeper into the mounts and exceeding this maximum
length may damage the display.