ICOM 241 User Manual
ICOM-manual
First steps
Power supply
The ICOM-200/201 uses a power supply with 8-12 VDC, 1A. Minus is placed
on the pin of the power supply connector. The current consumption is,
depending on the application, up to 400mA.
on the pin of the power supply connector. The current consumption is,
depending on the application, up to 400mA.
2
PC mode
After a reset or power-down the Tiny-Tiger
®
inside the ICOM-200/201 is
testing if the PC mode pin is „low“. In this case, the ICOM switches to PC
mode/Debug mode. Is the pin „high“, the ICOM starts in run mode. The time
between power-on and first activity on the I/O pins is approx. 230 msec.
mode/Debug mode. Is the pin „high“, the ICOM starts in run mode. The time
between power-on and first activity on the I/O pins is approx. 230 msec.
To set the ICOM-200/201 to PC mode, a reset or power-down is needed.
Setting the DIP switch to PC mode while in run mode is not sufficient.
Setting the DIP switch to PC mode while in run mode is not sufficient.
2-2
Wilke Technology GmbH • 0241 / 918 900 • http://www.wilke.de/ • support@wilke.de