Konica Minolta CS-2000A User Manual
72
Co
mm
un
ica
tio
n
This instrument can be used together with PC for mutual communication. Use the USB
cable (2m) CS-A32 supplied as standard accessory for this purpose.
The USB cable is allowed to plug/unplug while power is on, but it is recommended to
switch power off in this case.
cable (2m) CS-A32 supplied as standard accessory for this purpose.
The USB cable is allowed to plug/unplug while power is on, but it is recommended to
switch power off in this case.
Operation Procedure
1.
Switch power OFF (O).
2.
Connect the USB cable to the USB
connector of this instrument.
3.
Make sure that USB cable is all seated to
the USB connector.
Communication interface in this instrument conforms to USB..
Hold the USB cable plug in unplugging. Do not pull the cord.
Plug the USB cable to fit the connector entry point.
Hold the USB cable plug in unplugging. Do not pull the cord.
Plug the USB cable to fit the connector entry point.
To connect this instrument to PC, install the corresponding USB driver software. It is
attached to the data management software CS-S0w Professional in the standard
accessories. See installation guide of CS-S0w Professional for details on installing the
USB driver software to PC.
attached to the data management software CS-S0w Professional in the standard
accessories. See installation guide of CS-S0w Professional for details on installing the
USB driver software to PC.
Connecting to PC