Lucent Technologies 5 User Manual
MERLIN LEGEND Communications System Release 5.0
System Manager’s Guide
System Manager’s Guide
555-650-118
Issue 1
June 1997
System Components
Page 3-45
Power-Related Hardware
3
Power-Related Hardware
3
Your Lucent Technologies representative can plan for added power-related
hardware to provide your system with additional power and protection from power
surges, although most systems do not need extra surge protection. Other
accessories apply to system-specific conditions.
hardware to provide your system with additional power and protection from power
surges, although most systems do not need extra surge protection. Other
accessories apply to system-specific conditions.
Power Accessories
3
In a power failure, battery backup units can keep the system running for several
hours. When you connect adjuncts and adapters to telephones, the power
requirements for the telephones and the system increase. Sometimes it is
necessary to add a power accessory, described in this section, to an individual
telephone or to the system to accommodate these additional needs.
hours. When you connect adjuncts and adapters to telephones, the power
requirements for the telephones and the system increase. Sometimes it is
necessary to add a power accessory, described in this section, to an individual
telephone or to the system to accommodate these additional needs.
1.
Release 5.0 and later systems only; in earlier releases, a group can have only one primary
announcement device.
announcement device.
2.
If you use equipment that rebroadcasts music or other copyrighted materials, you may be
required to obtain a copyright license from and pay license fees to a third party such as
American Society of Composers, Artists, and Producers (ASCAP) or Broadcast Music
Incorporated (BMI). Or you can purchase a Magic on Hold system, which does not require
you to obtain such a license, from Lucent Technologies.
required to obtain a copyright license from and pay license fees to a third party such as
American Society of Composers, Artists, and Producers (ASCAP) or Broadcast Music
Incorporated (BMI). Or you can purchase a Magic on Hold system, which does not require
you to obtain such a license, from Lucent Technologies.
Table 3–5.
Continued
Equipment
Description
Loudspeaker Paging:
External paging system using DTMF
signaling. Customer paging systems
require an interface unit: for 3-wire
input, PagePal can be used.
External paging system using DTMF
signaling. Customer paging systems
require an interface unit: for 3-wire
input, PagePal can be used.
Connects to LS or GS/LS trunk jack.
Bidirectional paging supported; only one line jack
is needed for multizone paging.
is needed for multizone paging.
Message-waiting indicator
Connects to single-line phones.
Modem
Can be connected to:
008 OPT, 016 (Release 4.0 and later), or 012 T/R
extension jack
extension jack
MFM and MLX extension jack,
GPA and analog extension jack
Music On Hold:
2
Any FCC-registered 8-ohm music
source or recorded announcement
device.
source or recorded announcement
device.
Connects to LS or GS/LS trunk jack.
Music coupler required.
SMDR Printer:
Must be located within 50 ft. (15 m) of
control unit or use Asynchronous Data
Unit (ADU); should be 1,200-bpi serial
printer set at no parity and one stop bit.
Must be located within 50 ft. (15 m) of
control unit or use Asynchronous Data
Unit (ADU); should be 1,200-bpi serial
printer set at no parity and one stop bit.
Connects to SMDR jack on processor module.