Telex tr-200p User Manual
Push-to-Talk/Lock-to-Talk Switch:
For Model TR-200, this switch enables the talk function. Press the button
and hold down as long as required (Push-to-talk function), or if continuous
talk is required (lock-to-talk function), quickly press the button two times to
lock on. To release the talk function, press the button one time.
and hold down as long as required (Push-to-talk function), or if continuous
talk is required (lock-to-talk function), quickly press the button two times to
lock on. To release the talk function, press the button one time.
For Model TR-200P, this switch enables the transmit and audio function
and operates as described for TR-200.
and operates as described for TR-200.
Transmit LED Indicator: (Labeled “talk”) Will be illuminated whenever the
transmit function is enabled.
transmit function is enabled.
Headset Jack: 4 Pin XLR Connector for Input/Output. The headset jack will ac-
cept 5 different Telex Model headsets and 1 handset. See Recommended Headsets
starting on Page 14.
cept 5 different Telex Model headsets and 1 handset. See Recommended Headsets
starting on Page 14.
Figure 4
Headset Jack Wiring
Belt Clip: Combination Belt Clip/Battery Cover. Access to Battery Compartment,
Microphone Gain Control and Dynamic/Electret Switch is accomplished by re-
moval of belt clip via a quick release 1/4 turn fastener.(See Page 8)
Microphone Gain Control and Dynamic/Electret Switch is accomplished by re-
moval of belt clip via a quick release 1/4 turn fastener.(See Page 8)
Microphone Gain Control: Screwdriver adjustable by removing belt clip and pry-
ing out the small rubber plug to the right of the screw boss. Adjust the gain control
clockwise to increase microphone gain or counterclockwise to decrease micro-
phone gain. Replace rubber plug.
ing out the small rubber plug to the right of the screw boss. Adjust the gain control
clockwise to increase microphone gain or counterclockwise to decrease micro-
phone gain. Replace rubber plug.
Dynamic/Electret Switch: Place switch towards “D” when using a Dynamic Mi-
crophone or “E” when using an Electret Microphone.
crophone or “E” when using an Electret Microphone.
NOTE: All Telex headsets used with this intercom are dynamic microphones. Unit
is shipped in the “D” position.
is shipped in the “D” position.
Battery Compartment: Holds 6 AA batteries in a removable battery holder.
-5-
BTR-200/TR-200
MALE CONNECTORS
1
2
3
4
MICROPHONE
SHIELD (-)
SHIELD (-)
MICROPHONE
AUDIO (+)
AUDIO (+)
HEADPHONE
BALANCED
AUDIO
OUT
BALANCED
AUDIO
OUT