DELL 34XX User Manual
Syntax
set ssdCache [ssdCacheName]
addPhysicalDisks=(enclosureID1,drawerID1,slotID1 ...
enclosureIDn,drawerIDn,slotIDn)
Parameters
Parameter
Description
ssdCache
The alphanumeric identifier (including - and _) of
the SSD cache to which you want to add SSDs.
Enclose the identifier in square brackets ([ ]). If the
SSD cache name contains special characters or
consists only of numbers, you also must enclose
the identifier in double quotation marks (" ") inside
square brackets.
the SSD cache to which you want to add SSDs.
Enclose the identifier in square brackets ([ ]). If the
SSD cache name contains special characters or
consists only of numbers, you also must enclose
the identifier in double quotation marks (" ") inside
square brackets.
addPhysicalDisks
The physical disks that you want to add to the SSD
cache. For high-capacity expansion enclosures,
specify the enclosure ID value, the drawer ID value,
and the slot ID value for each SSD that you want to
add. For low-capacity expansion enclosures,
specify the enclosure ID value and the slot ID value
for each SSD that you want to add. Enclosure ID
values are 0 to 99. Drawer ID values are 0 to 4. Slot
ID values are 0 to 31. Enclose the enclosure ID
values, the drawer ID values, and the slot ID values
in parentheses.
cache. For high-capacity expansion enclosures,
specify the enclosure ID value, the drawer ID value,
and the slot ID value for each SSD that you want to
add. For low-capacity expansion enclosures,
specify the enclosure ID value and the slot ID value
for each SSD that you want to add. Enclosure ID
values are 0 to 99. Drawer ID values are 0 to 4. Slot
ID values are 0 to 31. Enclose the enclosure ID
values, the drawer ID values, and the slot ID values
in parentheses.
Notes
The SSD cache can contain any number of SSDs. The maximum size of the SSD cache is 5 TB, but might
be less depending on the size of the RAID controller module’s primary cache.
be less depending on the size of the RAID controller module’s primary cache.
Add Virtual Disk To Remote Replication Group
Description
This command adds a primary virtual disk to a remote replication group. This command is valid only on
the local storage array that contains the remote replication group to which you want to add the primary
virtual disk. A remote replication group has a repository virtual disk that is used to save data for all of the
point-in-time images that are part of the remote replication group.
the local storage array that contains the remote replication group to which you want to add the primary
virtual disk. A remote replication group has a repository virtual disk that is used to save data for all of the
point-in-time images that are part of the remote replication group.
Syntax
add virtualDisk="virtualDiskName"
asyncRemoteReplicationGroup="asyncRemoteReplicationGroupName"
remotePassword="password"
(repositoryVirtualDisk="repos_xxxx" | repositoryVirtualDisk=(diskGroupName
[capacity=capacityValue]) repositoryVirtualDisk=(diskPoolName
[capacity=capacityValue]))
139