DELL 34XX User Manual
Parameter
Description
NOTE: When you run a data loop-back test,
you can optionally specify a file that contains
a data pattern. If you do not specify a file, the
RAID controller module firmware provides a
default pattern.
you can optionally specify a file that contains
a data pattern. If you do not specify a file, the
RAID controller module firmware provides a
default pattern.
patternFile
File path and file name of the file that contains a
data pattern to use as test data. Enclose the path
and file name with quotation marks (" ").
data pattern to use as test data. Enclose the path
and file name with quotation marks (" ").
Diagnose RAID Controller Module iSCSI Host Cable
Description
NOTE: This command valid only for the PowerVault MD3800i storage array.
This command runs diagnostic tests on the copper cables between the iSCSI Host interface cards and a
RAID controller module. You can run diagnostics on a selected port or all ports. The ports must be able
to support the cable diagnostics. If the ports do not support cable diagnostics an error is returned
RAID controller module. You can run diagnostics on a selected port or all ports. The ports must be able
to support the cable diagnostics. If the ports do not support cable diagnostics an error is returned
Syntax
diagnose controller [(0 | 1)]
iscsiHostPort[(all | (0 | 1))]
testID=cableDiagnostics
Parameters
Parameter
Description
controller
Controller specifies the RAID controller module on
which you want to run the cable diagnostic test.
Valid RAID controller module identifier values are 0
and 1. The identifier value is 0 for the RAID
controller module on the top and 1 for the RAID
controller module on the bottom when viewed
from the rear of the enclosure. Enclose the RAID
controller module identifier in square brackets ([ ]).
If a RAID controller module is not specified, the MD
storage management software returns a syntax
error.
which you want to run the cable diagnostic test.
Valid RAID controller module identifier values are 0
and 1. The identifier value is 0 for the RAID
controller module on the top and 1 for the RAID
controller module on the bottom when viewed
from the rear of the enclosure. Enclose the RAID
controller module identifier in square brackets ([ ]).
If a RAID controller module is not specified, the MD
storage management software returns a syntax
error.
iscsiHostPort
Specifies the iSCSI host port on which you want to
run the diagnostic tests. You can either run the
diagnostics on all iSCSI host ports or run it on a
specific iSCSI host. Valid values for the specific
iSCSI host port identifiers are 0 or 1. Enclose the
iSCSI host port identifier in square brackets ([ ]).
run the diagnostic tests. You can either run the
diagnostics on all iSCSI host ports or run it on a
specific iSCSI host. Valid values for the specific
iSCSI host port identifiers are 0 or 1. Enclose the
iSCSI host port identifier in square brackets ([ ]).
217