DELL 34XX User Manual
Parameter
Description
sampleType
This parameter is optional. The default value for
sampleType is all.
• all—Data for all three sample types are reset.
• mostRecent—Statistics are reset for the most
sampleType is all.
• all—Data for all three sample types are reset.
• mostRecent—Statistics are reset for the most
recent 50 resynchronization samples.
• longestSyncTime—Statistics are reset for the
most recent 20 longest resynchronization
samples.
• errors—Statistics are reset for the most recent
20 failed resynchronization samples.
Notes
Statistics are reset for replicated virtual disks in the Primary role. The statistics that are reset include the
following data:
following data:
• Synchronization start time
• Synchronization type (manual or periodic)
• Synchronization duration
• Number of bytes sent
• Maximum and minimum write time (for a single write)
• Maximum and minimum synchronization data rate
• Total write time
• Repository utilization (%)
• Recovery point age
• Synchronization type (manual or periodic)
• Synchronization duration
• Number of bytes sent
• Maximum and minimum write time (for a single write)
• Maximum and minimum synchronization data rate
• Total write time
• Repository utilization (%)
• Recovery point age
Reset Storage Array Battery Install Date
Description
This command resets the age of the batteries in a storage array to zero days. You can reset the batteries
for an entire storage array or just the battery for a specific RAID controller module or in a specific battery
pack.
for an entire storage array or just the battery for a specific RAID controller module or in a specific battery
pack.
Syntax
reset storageArray batteryInstallDate controller=(0 | 1)
Parameter
Parameter
Description
controller
Specifies the RAID controller module that contains
the battery for which to reset the age. Valid RAID
controller module identifier values are 0 and 1. The
identifier value is 0 for the RAID controller module
on the top and 1 for the RAID controller module
on the bottom when viewed from the rear of the
the battery for which to reset the age. Valid RAID
controller module identifier values are 0 and 1. The
identifier value is 0 for the RAID controller module
on the top and 1 for the RAID controller module
on the bottom when viewed from the rear of the
259