Manualsbrain.com
  1. Manuals
  2. Brands
  3. DELL
  4. 34XX
  5. User Manual

DELL 34XX User Manual

Download
Page of 417
Parameters
Parameter
Description
controller
The RAID controller module for which you want to 
define properties. Valid RAID controller module 
identifiers are 0 or 1, where 0 is the RAID controller 
module in the top slot, and 1 is the RAID controller 
module in the bottom slot. Enclose the identifier 
for the RAID controller module in square brackets 
([ ]). If you do not specify a RAID controller module, 
the firmware for the controller returns a syntax 
error.
availability
The mode for the RAID controller module, which 
you can set to online, offline, or 
serviceMode (service).
ethernetPort
The attributes (options) for the management 
Ethernet ports. The entries to support this 
parameter are listed in the Syntax Element 
Statement Data table that follows. Many settings 
are possible, including setting the IP address, the 
gateway address, and the subnet mask address.
globalNVSRAMByte
A portion of the RAID controller module NVSRAM. 
Specify the region to be modified using the starting 
byte offset within the region and the byte value or 
bit value of the new data to be stored into the 
NVSRAM.
hostNVSRAMByte
The NVSRAM for the host-specific region. The 
setting specifies the host index for the specific 
host, the starting offset within the region, the 
number of bytes, and the byte value or bit value of 
the new data to be stored into the NVSRAM.
IPv4GatewayIP
The IP address of the node that provides the 
interface to the network. The address format for 
the IPv4 gateway is (0–255).(0–255).(0–255).
(0–255)
IPv6RouterAddress
The IP address of IPv6 router that connects two or 
more logical subnets. The address format for the 
IPv6 router is (0–FFFF):(0–FFFF):(0–FFFF):
(0–FFFF): (0–FFFF):(0–FFFF):(0–FFFF):
(0–FFFF).
iscsiHostPort
This parameter enables you to set options for the 
iSCSI ports on the RAID controller module. Select 
the specific iSCSI port and then select the options 
for that port. The iSCSI port identifier can be 0, 1 or 
2, 3. Refer to the information about your RAID 
controller module for the location and identifier of 
the ports.
300