DELL 34XX User Manual
Parameter
Description
this parameter only if you want to change the
virtual disk owner.
virtual disk owner.
readCacheEnabled
The setting to turn on or turn off the read cache.
To turn on the read cache, set this parameter to
TRUE. To turn off the read cache, set this
parameter to FALSE.
To turn on the read cache, set this parameter to
TRUE. To turn off the read cache, set this
parameter to FALSE.
writeCacheEnabled
The setting to turn on or turn off the write cache.
To turn on the write cache, set this parameter to
TRUE. To turn off the write cache, set this
parameter to FALSE.
To turn on the write cache, set this parameter to
TRUE. To turn off the write cache, set this
parameter to FALSE.
cacheReadPrefetch
The setting to turn on or turn off cache read
prefetch. To turn off cache read prefetch, set this
parameter to FALSE. To turn on cache read
prefetch, set this parameter to TRUE.
prefetch. To turn off cache read prefetch, set this
parameter to FALSE. To turn on cache read
prefetch, set this parameter to TRUE.
addCapacity
The setting to increase the storage size (capacity)
of the virtual disk for which you are defining
properties. Size is defined in units of bytes, KB, MB,
GB, or TB. The default value is bytes.
of the virtual disk for which you are defining
properties. Size is defined in units of bytes, KB, MB,
GB, or TB. The default value is bytes.
NOTE: A space must be added between the
last digit and the size (bytes, KB, MB, or GB) for
values greater than 9.
last digit and the size (bytes, KB, MB, or GB) for
values greater than 9.
addPhysicalDisks
Adds new physical disks to the virtual disk. Specify
the enclosure ID and slot ID for each physical disk
that you assign to the virtual disk. Enclosure ID
values are 0 to 99. Slot ID values are 0 to 31. You
must put brackets ([ ]) around the enclosure ID
values and the slot ID values. Use with the
addCapacity parameter if you must specify
additional physical disks to accommodate the new
size.
the enclosure ID and slot ID for each physical disk
that you assign to the virtual disk. Enclosure ID
values are 0 to 99. Slot ID values are 0 to 31. You
must put brackets ([ ]) around the enclosure ID
values and the slot ID values. Use with the
addCapacity parameter if you must specify
additional physical disks to accommodate the new
size.
consistencyCheckEnabled
Turns consistency checking during a media scan
on or off. To turn consistency checking on, set to
TRUE. To turn consistency checking off, set to
FALSE.
on or off. To turn consistency checking on, set to
TRUE. To turn consistency checking off, set to
FALSE.
segmentSize
Amount of data (in kilobytes) that the RAID
controller module writes on a single physical disk
in a virtual disk before writing data on the next
physical disk. Valid values are 8, 16, 32, 64, 128,
256, or 512. For information about the
segmentSize parameter, see Using The Auto
Configure Command.
controller module writes on a single physical disk
in a virtual disk before writing data on the next
physical disk. Valid values are 8, 16, 32, 64, 128,
256, or 512. For information about the
segmentSize parameter, see Using The Auto
Configure Command.
331