DELL 34XX User Manual
Parameter
Description
path. The connectivity test sends an inter-RAID
controller module message between the
storage arrays, and then validates that the
corresponding remote replication group on the
remote storage array exists. It also validates that
the virtual disk members of the remote
replication group on the remote system match
the virtual disk members of the remote
replication group on the local system.
• Latency—Sends a SCSI test unit command to
each virtual disk on the remote storage array
associated with the remote replication group to
test the minimum, average, and maximum
latency.
• Bandwidth—Sends two inter-RAID controller
module messages to the remote storage array
to test the minimum, average, and maximum
bandwidth as well as the negotiated link speed
of the port on the RAID controller module
performing the test.
• Port connections—Shows the port that is
being used for replicating on the local storage
array and the port that is receiving the
replicated data on the remote storage array.
Test SNMP Trap Destination
Description
This command tests the connection and identification of the trap receiver for a specific Simple Network
Management Protocol (SNMP) community. This command tests the trap destination by sending a trap
message to the trap receiver.
Management Protocol (SNMP) community. This command tests the trap destination by sending a trap
message to the trap receiver.
Syntax
start snmpTrapDestination trapReceiverIP=ipAddress
communityName="communityName"
Parameters
Parameter
Description
trapReceiverIP
The IP address of the SNMP manager to which you
want to send trap messages.
communityName
The name of the SNMP community for which you
want to send trap messages.
410