DELL 32XX User Manual
Show RAID Controller Module NVSRAM
Description
This command returns a list of the NVSRAM byte values for the specified host type. If you do not enter
the optional parameters, this command returns a list of all NVSRAM byte values.
the optional parameters, this command returns a list of all NVSRAM byte values.
Syntax
show (allControllers | controller [(0 | 1)]) NVSRAM [hostType=(
hostTypeIndexLabel | host="hostName")]
Parameters
Parameter
Description
allControllers
Returns information about both RAID controller
modules in the storage array.
modules in the storage array.
controller
Returns information about a specific RAID
controller module in the storage array. Valid RAID
controller module identifier values are 0 and 1. The
identifier value is 0 for the RAID controller module
on the top and 1 for the RAID controller module
on the bottom when viewed from the rear of the
enclosure. You must put brackets ([ ]) around the
RAID controller module identifier.
controller module in the storage array. Valid RAID
controller module identifier values are 0 and 1. The
identifier value is 0 for the RAID controller module
on the top and 1 for the RAID controller module
on the bottom when viewed from the rear of the
enclosure. You must put brackets ([ ]) around the
RAID controller module identifier.
hostType
Specifies the index label or number of the host
type. Use the show storageArray
hostTypeTable command to generate a list of
available host type identifiers.
type. Use the show storageArray
hostTypeTable command to generate a list of
available host type identifiers.
host
Specifies the name of the host connected to the
RAID controller modules. You must put quotation
marks (" ") around the host name.
RAID controller modules. You must put quotation
marks (" ") around the host name.
NOTE: Use the show controller NVSRAM command to display parts or all of the NVSRAM before
using the set controller command to change NVSRAM values.
using the set controller command to change NVSRAM values.
Show Remote Replication Group
Description
This command displays configuration information for one or more remote replication groups. This
command also displays the remote replicated pairs associated with each remote replication group,
including incomplete remote replicated pairs.
command also displays the remote replicated pairs associated with each remote replication group,
including incomplete remote replicated pairs.
You can also use this command to show the progress of periodic data synchronization on all of the
replicated pairs within the remote replication group.
replicated pairs within the remote replication group.
349