Intel Intel Core2 Extreme QX6850 HH80562XJ0808M Data Sheet

14

Datasheet

The Voltage Identification (VID) specification for the processor is defined by the Voltage 

LGA775 Socket. The voltage set by the VID signals is the reference VR output voltage 

to be delivered to the processor V

CC

 pins (see 

CC

 overshoot 

specifications). Refer to 

 for the DC specifications for these signals. Voltages 

for each processor frequency is provided in

 

Individual processor VID values may be calibrated during manufacturing such that two 

devices at the same core speed may have different default VID settings. This is 

reflected by the VID Range values provided in 

. Refer to the In tel® Core™2 

Δ

Δ

 Sequence Specification Update for further details on specific valid core 

frequency and VID values of the processor. Note that this differs from the VID 

employed by the processor during a power management event (Thermal Monitor 2, 

Enhanced Intel SpeedStep

®

 Technology, or Extended HALT State). 

The processor uses the voltage identification signals, VID[7:0], to support automatic 

selection of power supply voltages. 

 specifies the voltage level corresponding to 

the state of VID[7:0]. A ‘1’ in this table refers to a high voltage level and a ‘0’ refers to 

a low voltage level. If the processor socket is empty (VID[7:0] = 11111111), or the 

voltage regulation circuit cannot supply the voltage that is requested, it must disable 

itself. The Voltage Regulator-Down (VRD) 11.0 Processor Power Delivery Design 

Guidelines For Desktop LGA775 Socket defines VID [7:0], VID7 and VID0 are not used 

on the processor; VID0 and VID7 are strapped to V

SS

 on the processor package. VID0 

and VID7 must be connected to the VR controller for compatibility with future 

processors.

The processor provides the ability to operate while transitioning to an adjacent VID and 

its associated processor core voltage (V

CC

). This will represent a DC shift in the load 

line. It should be noted that a low-to-high or high-to-low voltage state change may 

result in as many VID transitions as necessary to reach the target core voltage. 

Transitions above the specified VID are not permitted. 

 includes VID step sizes 

and DC shift ranges. Minimum and maximum voltages must be maintained as shown in 

as measured across the VCC_SENSE and VSS_SENSE lands.

The VRM or VRD used must be capable of regulating its output to the value defined by 

the new VID. DC specifications for dynamic VID transitions are included in 

 and 

. Refer to the Voltage Regulator-Down (VRD) 11.0 Processor Power Delivery 

Design Guidelines For Desktop LGA775 Socket for further details.