HP (Hewlett-Packard) 179776-002 User Manual

Installing Hardware Options

For use with 350-MHz or greater Intel processor-based servers only

Writer: Cheri Stewart   Project: Compaq ProLiant 3000 Servers Setup and Installation Guide   Comments: 179776-002

File Name: E-CH04.DOC   Last Saved On: 1/12/99 1:28 PM

COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED

Fan 3

(IO)

Fan 2

(CPU Redundant)

Fan 4 (IO Redundant)

Fan 1

(CPU)

Figure 4-10.    Fan header location

These instructions cover the removal of the hot-plug SCSI drive cage and
removable media cage, installation of the Simplex Enable board, and
installation of optional tape drive.

NOTE:    Installation of the Simplex Enable board disables controller duplexing
of the internal SCSI drives. Refer to the 

Compaq ProLiant 3000 Cabling

Guidelines Reference Guide for more information on configurating duplex and
simplex modes.

NOTE:    Your drive cage may differ from the model illustrated.

1.  Prepare the server for installation. See section "Preparing the Server,"

outlined earlier in this chapter.

2.  Loosen the thumbscrews on the front of the drive cage. See

Figure 4-11.

3.  Pull out the latch at the back of the drive cage (shown in Figure 4-12)

and pull out the drive cage 2 to 3 inches to allow better access to cables.