DELL E23S Series User Manual
4.
Close the system.
5.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
System Board
Removing The System Board
CAUTION: Many repairs may only be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or
telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your
warranty. Read and follow the safety instructions that came with the product.
CAUTION: If you are using the Trusted Program Module (TPM) with an encryption key, you may be prompted to
create a recovery key during program or System Setup. Be sure to create and safely store this recovery key. If you
replace this system board, you must supply the recovery key when you restart your system or program before you
can access the encrypted data on your hard drives.
1.
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2.
If installed, remove the front bezel.
3.
Open the system.
4.
Disconnect the cables to the system board, SAS backplane, and control panel board.
5.
Remove the following:
a. cable management tray
b. cooling fans (6)
c. memory risers (8)
d. memory riser and fan cage
e. fan tray
a. cable management tray
b. cooling fans (6)
c. memory risers (8)
d. memory riser and fan cage
e. fan tray
WARNING: The heat sink is hot to touch for some time after the system has been powered down. Ensure
that you do not touch the heat sink(s) while removing the system board.
that you do not touch the heat sink(s) while removing the system board.
f. processor heat sink/heat sink blanks
g. processors (if required)
h. power supply(s)
i. power supply unit bays with power distribution boards (2)
j. NDC riser (I/O riser 1)
k. expansion-card risers, expansion card(s)/integrated storage controller cards
l. internal USB key (if installed)
m. SAS backplanes
n. optical drive
g. processors (if required)
h. power supply(s)
i. power supply unit bays with power distribution boards (2)
j. NDC riser (I/O riser 1)
k. expansion-card risers, expansion card(s)/integrated storage controller cards
l. internal USB key (if installed)
m. SAS backplanes
n. optical drive
6.
Disconnect all cables from the system board.
CAUTION: Do not lift the system board assembly by holding a memory module, processor, or other
components.
components.
7.
Grasp the system-board using the memory riser guides, lift the blue release pin and slide the system board toward
the front of the system.
113