Makita DCS461 User Manual

17

In order to prevent carburetor icing in conditions of low tempe-
rature combined with high humidity, and below + 5°C in order 
to get up to operating temperature faster, heated air can be 
taken from the cylinder.

Remove the cover (see “Cleaning the air Þ lter”).

Remove the insert (7) and insert it as shown for winter opera-
tion.

If the temperature is above + 5°C (40°F) the engine needs to 
induct cold air. If this is not done, the cylinder and piston 
can be damaged!

For temperatures above + 5°C (40°F) turn the insert 180° so 
that after it is inserted the induction opening (8) is closed.

Put the cover back on.

Note: When working in snow, the insert (7) can be replaced by a 
specal insert with nylon screen, which prevents snow from getting 
in. It is available as an accessory, part no. 957 173 250.

Symbol

 

 

on top when inserted – Normal operation

Symbol

 

 

on top when inserted – Winter operation

Start the engine as described above (have a secure footing, 
place the chain saw on the ground so that the chain and guide 
bar are not near anything).

Hold the front handle Þ rmly, with your other hand on the rear 
grip.

Let the engine run at medium speed and push the handguard 
(6) in the direction of the arrow using the back of your hand, 
until the chain brake engages. The chain should now stop im-
mediately.

Bring the engine back to idle and release the chain brake.