Stow SCT46 User Manual

3.

Tighten cable clamp screw.

4.

After the cable has been installed on the engine, work the
throttle lever to verify the  throttle cable is at the proper
length.  Adjust the cable as necessary.

5.

Reinstall the air cleaner housing if previously removed.

Before the trowel can be put into operation there are some
components that must be installed before the trowel can be used.
This section provided general instructions on how to install those
components.

1.

Install the 

handle tube to the gearbox as shown in (Figure 5).

The mounting hardware should be contained in the shipping
container.

2. Connect the throttle cable to the engine. (Figure 7).  (The air

cleaner housing may have to be removed to provide access
for throttle cable installation.) When connecting the cable
housing, make sure that no more than 

1/4" (6.4mm) of the

cable housing protrudes past the housing clamp on the
engine.

1.

Set the 

throttle  (Figure 6) to the idle position (lever away

from the operator).