ACR Electronics 2607 User Manual

User Manual

Y1-03-0203 Rev.L

1 Starting the NAUTICAST

1.1 Initial Set Up of the NAUTICAST for operation

ATTENTION: IMO REGULATIONS MANDATE THAT YOU ENTER THIS INFORMATION.

After installing the antennas and hardware the following User, Voyage related and Ship Settings
data needs to be entered. Upon Start-up (Applying power) enter the following information.

a) Enter MMSI Number - See section 1.2 on entering information.

During the initial boot or after “factory settings” the user is asked to enter a valid MMSI
number. As long as this is not done, the system does not transmit. This appears as Alarm-ID
56 with the text “AIS: ENTER MMSI NUMBER”.

b) Enter IMO Number - See section 1.2 on Entering information.

c) Ship Settings Data - After initial entry of the Ship Settings Data any changes in the

information below should be edited accordingly. See section 1.3 on entering information.

  Enter Call Sign
  Enter Ships Name
  Enter Length of Ship
  Enter Beam of Ship
  Enter Internal GPS antenna Position
  Enter External GPS Antenna Position (If applicable).
  Enter Ship Type

d) Voyage related Data

– After initial entry of the Voyage related Data any changes in the

information below should be edited accordingly.
See paragraph 1.4 above on entering information.

  Enter Cargo Type
  Enter Draught
  Enter Destination
  Enter ETA
  Enter Navigation Status.

e) Password

– Service and User passwords see section 1.5 and Appendix 7.2

LAT: N/A       SOG: N/A 00/00/00
LON: N/A COG: N/A 24:60:60
IntN/A: STOP ! 7A 1T

++++++++++++++++++++++++++++++++++++++++
Time 24:60 00/00
[!] ALARM ID:56
AIS: ENTER MMSI NUMBER

Please press OK to enter MMSI number!
Tx temporary suppressed

++++++++++++++++++++++++++++++++++++++++

----------------------------------------
| OK | | |