Acu-Rite #02036WB User Manual

Remove the battery 

compartment cover. 

Install 2 fresh “AA” 

batteries, as shown.

BATTERIES MUST BE 

INSTALLED FOR THE 

SENSOR TO OPERATE. 

Extended periods of cold temperatures (below -4ºF / -20ºC) can cause 

alkaline batteries to function improperly. This causes the outdoor sensor 

to stop transmitting data. Use lithium batteries in low temperature 

conditions to ensure continuous operation of the outdoor sensor.

To allow for more than one weather station and wireless sensor to be 

used within close proximity, the display console and outdoor sensor 

have a small switch labeled “A B C” within the battery compartments. 

This switch allows you to select one of 3 wireless modes. 

PLEASE NOTE: Both switches MUST be set in matching positions (either 

A, B, or C) for wireless communication.

SWITCH SELECTION

MUST MATCH

DISPLAY UNIT

SWITCH SELECTION

BATTERY SAFETY: Clean the battery contacts and also those of the device prior to battery installation. Remove batteries from 

equipment which is not to be used for an extended period of time. Follow the polarity (+/-) diagram in the battery 

compartment. Promptly remove dead batteries from the device. Dispose of used batteries properly. Only batteries of the same 

or equivalent type as recommended are to be used. DO NOT incinerate used batteries. DO NOT dispose of batteries in fire, as 

batteries may explode or leak. DO NOT mix old and new batteries or types of batteries (alkaline/standard). DO NOT use 

rechargeable batteries. DO NOT recharge non-rechargeable batteries. DO NOT short-circuit the supply terminals.

 

SWITCH SELECTION

MUST MATCH

WIRELESS SENSOR

SWITCH SELECTION

Remove the battery 

compartment cover. 

Install 3 fresh “AA” 

batteries as shown 

here.