AT&T MLS-6TM User Manual
Toll Call Prefix
Code:
#402
Description:
Phone companies recognize long distance calls in either of two
ways:
a telephone number preceded by 0 or 1 plus an area code or a tele-
phone number preceded only by an area code. Use this procedure to tell the
PARTNER Plus system which method your phone company uses.
PARTNER Plus system which method your phone company uses.
Valid Entries: ✓
1
= 0
or 1 plus the area code
2 = Area code only (0 or 1 not necessary)
Programming Steps:
1
. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 4 ] [ 0 ] [ 3 ]. The
display reads:
Toll Call Prefix
1 0/1 + AreaCd
2. To change the toll call prefix, press [ Next Data ] until the appropriate setting
appears. For example,
Toll Call Prefix
2 Area Code Only
System Password
Code:
#403
Description:
Identifies the 4-digit password that lets a user override Outgoing
Call Restrictions (#401). You can also use the password with Night Service
(#503 and #504) to restrict after-hours dialing.
(#503 and #504) to restrict after-hours dialing.
Valid Entries:
Any 4 digits
Entering the password allows you
Considerations:
If you assign a password using this procedure, you must enter
to override several dialing restric-
tions. See appendix B for a sum-
tions. See appendix B for a sum-
the password when-turning Night Service (#503) on or off.
mary of dialing restrictions.
Programming Steps:
1. Press [ Feature ] [ 0 ] [ 0 ] [ System Program ] [ System Program ] [ # ] [ 4 ] [ 0 ] [ 3 ]. The
display reads:
Set Password
Data----
If a password has previously been set, it will appear on the display.
2. Enter or change the password using the dial pad. For example, to set the
password to 5747, press [ 5 ] [ 7 ] [ 4 ] [ 7 ] . The display reads:
Set Password
Data5747
To remove a password, press [ Remove ]
✓
= Factory Setting
To go to the next procedure: [ Next Proc ]
Togo to a specific procedure: [
# ] [ x ] [ x ] [ x ]
To go to the previous procedure: [ Prev Proc ]
(where XXX is the procedure number)
To return data to the factory setting: [
Remove ]
To exit system programming: [ Feature ] [ 0 ] [ 0 ]
System Programming 3-19