Sony 500A3WE User Guide

2

 (GB)

The model and serial numbers are located on the rear.

Record the model and serial numbers in the spaces provided

below. Refer to these numbers whenever you call upon your

Sony dealer regarding this product.

Model No.

Serial No.

This equipment has been tested and found to comply with

the limits for a Class A digital device, pursuant to Part 15 of

the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This

equipment generates, uses, and can radiate radio frequency

energy and, if not installed and used in accordance with the

instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential

area is likely to cause harmful interference in which case the

user will be required to correct the interference at his own

expense.

You are cautioned that any changes or modifications not

expressly approved in this manual could void your authority

to operate this equipment.

This class A digital apparatus complies with Canadian ICES-

003.

This is a Class A product. In a domestic environment, this

product may cause radio interference in which case the user

may be required to take adequate measures.

or

Clamps

The wires in this mains lead are coloured in accordance with

the following code:

As the colours of the wires in the mains lead of this

apparatus may not correspond with the coloured markings

identifying the terminals in your plug proceed as follows:

The wire which is coloured green-and-yellow must be

connected to the terminal in the plug which is marked with

the letter E or by the safety earth symbol 

I

 or coloured

green or green-and-yellow.

The wire which is coloured blue must be connected to the

terminal which is marked with the letter N or coloured black.

The wire which is coloured brown must be connected to the

terminal which is marked with the letter L or coloured red.

Bij dit produkt zijn batterijen geleverd.

Wanneer deze leeg zijn, moet u ze niet

weggooien maar inleveren als KCA.

The socket-outlet should be installed near the equipment

and be easily accessible.

When you connect a computer to this monitor,
attach the supplied ferrite cores. If you do not do
this, this monitor will not conform to mandatory
FCC/IC/CE (EN55022) standards.

Set the ferrite cores on the both ends of the AC
power cord. Close the lid tightly until the clamps
click.