Husqvarna LOGTH2448T User Manual

6

(2) Keys

(1) Oil Drain Tube 
For Future Use

Your new tractor has been assembled at the factory with the exception of those parts left 
unassembled for shipping purposes. 

When right or left hand is mentioned in 
this man ual, it means, from your point of 
view, when you are in the op er at ing po si-
tion (seat ed be hind the steer ing wheel).

UNPACK CARTON
1.   Cut along dashed lines on all four pan-

els of carton. Remove end panels and 
lay side panels fl at.

2.   Remove protective materials from trac-

tor hood and grille.

IMPORTANT: Check for and remove any 
staples in skid that may puncture tires 
where tractor is to roll off skid.
CHECK BATTERY
1.   Lift hood to raised position.
NOTE: If this battery is put into service 
after month and year indicated on label 
(L) (label is located between terminals) 
charge battery for minimum of one hour at 
6-10 amps. (See "BATTERY" in Mainte-
nance  section of this manual for charging 
instructions).

02931

ADJUST SEAT 
1.   Sit in seat.
2.   Lift up adjustment lever (A) and slide 

seat until a comfortable position is 
reached which allows you to press 
clutch/brake pedal all the way down.

3.   Release lever to lock seat in position.

NOTE: You may now roll or drive your 
tractor off the skid. Follow the ap pro pri ate 
instruction below to remove the tractor 
from the skid.

  WARNING: Before start ing, read, un-

 der stand and fol low all in struc tions in the 
Op er a tion section of this man u al. Be sure 
tractor is in a well-ventilated area. Be sure 
the area in  front of tractor is clear of other 
peo ple and objects.

1.   Raise attachment lift lever to its highest 

po si tion.

2.   Release parking brake by de press ing 

clutch/brake ped al.

3.   Place freewheel control in "trans-

 mis sion disengaged position" (See “TO 
TRANS PORT” in the Op er a tion section 
of this manual).