Kenwood TK-3230 User Manual

 To use Incoming Call Notification, you must set up a QT tone 

or a DQT code {page 16}.

Incoming Call Notification is used to inform you of when a call 

is being received.  When activated, a tone is emitted when a 

busy signal is received and the QT/ DQT signaling matches.

•  The tone will sound for 15 seconds before turning off.
•  While the tone sounds, you will not hear any audio from the 

speaker.  Press any key to turn the tone off and listen to the 

received call.

After the call is finished, the transceiver will wait for 10 seconds 

before resetting.  If you receive a new call within those 10 

seconds, the tone will not sound.  If no call is received within 

10 seconds, Incoming Call Notification will reset so that the 

next time a call is received, the tone will sound again.
To turn Incoming Call Notification on or off:
1

  With the transceiver power OFF, press and hold the MENU 

key while turning the transceiver power ON (for 1 second).

  Press the   or   key to select “   ”.

  Press the MENU key then press   or   to select “ 

 ”  

(incoming call notification off), or “ 

 ” (incoming call 

notification on).

  Press the MENU key to exit the selection.

  Press the PTT, MON, or CAL key to exit Setting Mode.