3com WXR100 3CRWXR10095A User Manual

C

HAPTER

 10: N

ETWORK

 D

OMAIN

 C

OMMANDS

Sets the IP address of a Network Domain seed. This command is used for 
configuring a WX as a member of a Network Domain. You can specify 
multiple Network Domain seeds and configure one as the primary seed. 

Syntax — 

set network-domain mode member seed-ip ip-addr 

[affinity num]

„

— IP address of the Network Domain seed, in dotted 

decimal notation.

„

— Preference for using the specified Network Domain seed. You 

can specify a value from 1 through 10. A higher number indicates a 
greater preference.

Defaults — The default affinity for a Network Domain seed is 5.

Access — Enabled.

History —Introduced in MSS 4.1.

Usage — You can specify multiple Network Domain seeds on the WX. 
When the WX needs to connect to a Network Domain seed, it first 
attempts to connect to the seed with the highest affinity. If that seed is 
unavailable, the WX attempts to connect to the seed with the 
next-highest affinity. After a connection is made to a non-highest-affinity 
seed, the WX switch then periodically attempts to connect to the 
highest-affinity seed.

Examples — The following command sets the WX switch as a member 
of the Network Domain whose seed has the IP address 192.168.1.8:

success: change accepted.

The following command sets the WX as a member of a Network Domain 
whose seed has the IP address 192.168.9.254 and sets the affinity for 
that seed to 7. If the WX specifies other Network Domain seeds, and they 
are configured with the default affinity of 5, then 192.168.9.254 
becomes the primary Network Domain seed for this WX.

WX1200# set network-domain mode member seed-ip 192.168.9.254 

success: change accepted.