3com WXR100 3CRWXR10095A User Manual
362
C
HAPTER
11: M
ANAGED
A
CCESS
P
OINT
C
OMMANDS
reset ap
Restarts a MAP access point.
Syntax —
reset ap ap-number
ap
ap-number
— Index value that identifies the MAP on the WX.
dap
dap-num
— Number of a Distributed MAP to reset.
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0. Version 6.0 removed the dap
option.
option.
Usage — When you enter this command, the MAP drops all sessions and
reboots.
reboots.
CAUTION: Restarting a MAP can cause data loss for users who are
currently associated with the MAP.
currently associated with the MAP.
Examples — The following command resets MAP 7:
WX1200# reset ap 7
This will reset specified AP devices.
Would you like to continue? (y/n)y
success: rebooting ap attached to port 7
set ap auto
Creates a profile for automatic configuration of MAPs.
Syntax —
set ap auto
Defaults — None.
Access — Enabled.
History — Introduced in MSS 4.0. Version 6.0 removed the dap option.
Usage — Table 71 lists the configurable profile parameters and their
defaults. The only parameter that requires configuration is the profile
mode. The profile is disabled by default. To use the profile to configure
Distributed MAPs, you must enable the profile using the set ap auto
mode enable command.
defaults. The only parameter that requires configuration is the profile
mode. The profile is disabled by default. To use the profile to configure
Distributed MAPs, you must enable the profile using the set ap auto
mode enable command.