3com WXR100 3CRWXR10095A User Manual

Deprecated in MSS Version 6.0. To configure RF load balancing, see “set 
load-balancing mode” on page 398.

Specifies information about the physical location of a MAP.

Syntax — 

set ap port-list location string

Examples — The following command specifies the location of MAP 7 as 
the conference room:

WX4400# set ap 7 location ‘the conference room’

success: change accepted.

„

„

Enables local switching for a specified MAP.

Syntax — 

set ap ap-number local-switching mode {enable | 

disable}]

„

— Index value that identifies the MAP on the WX. 

„

 {

 | 

} — Enables or disables local switching for the 

MAP.

 — 

Local switching is disabled by default.

 — 

Enabled.

 —

Introduced in MSS Version 6.0.

 — 

Local switching allows traffic for specified VLANs to be 

switched by the 

MAP itself, instead of being tunneled back to a WX. The 

VLANs for which local switching is performed are specified in a VLAN 
profile.

Local switching can be enabled on MSPs that are connected to the WX 
via an intermediate Layer 2 or Layer 3 network. Local switching is not 
supported for MAPs that are directly connected to an WX.