3com WXR100 3CRWXR10095A User Manual

C

HAPTER

 11: M

ANAGED

 A

CCESS

 P

OINT

 C

OMMANDS

Creates a new radio profile, and disables or reenables all MAP radios that 
are using a specific profile.

Syntax — 

set radio-profile name [mode {enable | disable}]

„

radio-profile name

 — Radio profile name of up to 16 alphanumeric 

characters, with no spaces.

Use this command without the mode enable or mode disable 
option to create a new profile.

„

 — Enables the radios that use this profile.

„

 — Disables the radios that use this profile.

Defaults — Each radio profile that you create has a set of properties with 
factory default values that you can change with the other set 
radio-profile commands in this chapter. 

Table 72 lists the parameters controlled by a radio profile and their 
default values.

Table 72   Defaults for Radio Profile Parameters

active-scan

enable

Sends probe any requests (probe requests 
with a null SSID name) to solicit probe 
responses from other access points.

auto-tune

enable

Allows dynamic configuration of channel 
and power settings by MSS.

beacon-interval

100

Waits 100 ms between beacons.

countermeasures

Not configured Does not issue countermeasures against 

any device.

dtim-interval

1

Sends the delivery traffic indication map 
(DTIM) after every beacon.

frag-threshold

2346

Uses the short-retry-count for frames 
shorter than 2346 bytes and uses the 
long-retry-count for frames that are 2346 
bytes or longer.

max-rx-lifetime

2000

Allows a received frame to stay in the 
buffer for up to 2000 ms (2 seconds).