3com WXR100 3CRWXR10095A User Manual
534
C
HAPTER
13: IGMP S
NOOPING
C
OMMANDS
Defaults — By default, no ports are static multicast receiver ports.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — You cannot add MAP access ports or wired authentication
ports as static multicast ports. However, MSS can dynamically add these
port types to the list of multicast ports based on multicast traffic.
ports as static multicast ports. However, MSS can dynamically add these
port types to the list of multicast ports based on multicast traffic.
Examples — The following command adds port 7 as a static multicast
receiver port:
receiver port:
WX1200# set igmp receiver port 7 enable
success: change accepted.
The following command removes port 7 from the list of static multicast
receiver ports:
receiver ports:
WX1200# set igmp receiver port 7 disable
success: change accepted.
See Also
set igmp rv
Changes the robustness value for one VLAN or all VLANs on a WX.
Robustness adjusts the IGMP timers to the amount of traffic loss that
occurs on the network.
Robustness adjusts the IGMP timers to the amount of traffic loss that
occurs on the network.
Syntax —
set igmp rv num [vlan vlan-id]
num
— Robustness value. You can specify a value from 2 through 255.
Set the robustness value higher to adjust for more traffic loss.
vlan vlan-id
— VLAN name or number. If you do not specify a
VLAN, MSS changes the robustness value for all VLANs.
Defaults — The default robustness value for all VLANs is 2.
Access — Enabled.
History — Introduced in MSS Version 3.0.