D-Link DWC-1000 User Manual

Page of 181
Wireless Controller 
 
User Manual 
17  
2.1.2  Configuring IPv6 Router Advertisements 
Router Advertisements are analogous to IPv4 DHCP assignments for LAN clients, in 
that  the  router  will  assign  an  IP  address  and  supporting  network  information  to 
devices  that  are  configured  to  accept  such  details.  Rout er  Advertisement  is  required 
in  an  IPv6  network  is  required  for  stateless  auto  configuration  of  the  IPv6  LAN.  By 
configuring  the  Router  Advertisement  Daemon  on  this  router,  the  DWC-1000  will 
listen  on  the  LAN  for  router  solicitations  and  respond  to  these  L AN  hosts  with 
router advisements. 
RADVD 
Advanced > IPv6 > IPv6 LAN > Router Advertisement  
To  support  stateless  IPv6  auto  configuration  on  the  LAN,  set  the  RADVD  status  to 
Enable. The following settings are used to configure RADVD:  
 
Advertise  Mode:  Select  Unsolicited  Multicast  to  send  router  advertisements 
(RA‘s)  to  all  interfaces  in  the  multicast  group.  To  restrict  RA‘s  to  well 
known  IPv6  addresses  on  the  LAN,  and  thereby  reduce  overall  network 
traffic, select Unicast only.  
 
Advertise  Interval:  When  advertisements  are  unsolicited  multicast  packets, 
this  interval  sets  the  maximum  time  between  advertisements  from  the 
interface.  The  actual  duration  between  advertisements  is  a  random  value 
between one third of this field and this field. The default is 30 seconds.  
 
RA Flags: The router advertisements (RA‘s) can be sent with one or both of 
these  flags.  Chose  Managed  to  use  the  administered  /stateful  protocol  for 
address  auto  configuration.  If  the  Other  flag  is  selected  the  host  uses 
administered/stateful protocol for  non-address auto configuration.  
 
Router  Preference:  this  low/medium/high  parameter  determines  the 
preference  associated  with  the  RADVD  process  of  the  router.  This  is  useful 
if  there  are  other  RADVD  enabled  devices  on  the  LAN  as  it  helps  avoid 
conflicts for IPv6 clients. 
 
MTU:  The  router  advertisement  will  set  this  maximum  transmission  unit 
(MTU) value for all nodes in the LAN that are autoconfigured by the router. 
The default is 1500. 
 
Router  Lifetime:  This  value  is  present  in  RA‘s  and  indicates  the  usefulnes s 
of  this  router  as  a  default  router  for  the  interface.  The  default  is  3600 
seconds.  Upon  expiration  of  this  value,  a  new  RADVD  exchange  must  take 
place between the host and this router.