3com WX2200 3CRWX220095A User Manual
300
C
HAPTER
10: N
ETWORK
D
OMAIN
C
OMMANDS
set
network-domain
mode seed
domain-name
network-domain
mode seed
domain-name
Creates a Network Domain by setting the current WX as a seed device
and naming the Network Domain.
and naming the Network Domain.
Syntax —
set network-domain mode seed domain-name
net-domain-name
net-domain-name
— Name of the Network Domain. Specify between
1 and 16 characters with no spaces.
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.1.
Usage — Before you use this command, the current WX must have its IP
address set with the set system ip-address command. After you enter
this command, Network Domain traffic is sent and received from the
specified IP address.
address set with the set system ip-address command. After you enter
this command, Network Domain traffic is sent and received from the
specified IP address.
You can configure multiple WX switches as Network Domain seeds. If you
do this, you must identify them as peers by using the set network
domain peer command.
do this, you must identify them as peers by using the set network
domain peer command.
Examples — The following command creates a Network Domain named
California with the current WX as a seed:
California with the current WX as a seed:
WX1200# set network-domain mode seed domain-name California
success: change accepted.
The seed switch in a Network Domain must also be configured as a
member of the Network Domain, with the specified seed IP address
pointing to the seed itself.
member of the Network Domain, with the specified seed IP address
pointing to the seed itself.
set network-domain mode member seed-ip ip-addr [affinity num]
For example, the following command sets the current WX switch as a
member of a Network Domain where the WX switch with IP address
192.168.9.254 is a seed:
member of a Network Domain where the WX switch with IP address
192.168.9.254 is a seed:
WX1200# set network-domain mode member seed-ip 192.168.9.254
success: change accepted.
See Also