Intel PCI User Manual

116

The following table lists the initial values for the IPv4 addresses.

Note: Since the 82546GB/EB is a dual-port device, the IPv4 Address in 15h-16h corresponds to LAN B, 

and the IPv4 Address in 25h-26h corresponds to LAN A.

The following table lists the initial values for the IPv6 addresses.

Note: Since the 82546GB/EB is a dual-port device, the IPv6 Address in 17h-1Eh corresponds to LAN B, 

and the IPv6 Address in 27h-2Eh corresponds to LAN A.

This EEPROM word specifies the hardware defaults for the LEDCTL register fields controlling the 

LED0/(LINK_UP#) and LED2/LINK100 output behaviors. Refer to 

 for the LED 

Control bit descriptions and 

 for the Mode Encodings.

Note: A value of 0602h is used to configure default hardware LED behavior equivalent to 82544-based 

Copper adapters (LED0/LINK_UP#, LED1/ACTIVITY# (blinking), LED2/LINK100#, and 
LED3/LINK1000#).

The boot agent software configuration is controlled by the EEPROM with the main setup options 
stored in word 30h. These options are those that can be changed by using the Control-S setup menu 

or by using the IBA Intel Boot Agent utility.

Note: The 82541ER does not support the Intel Boot Agent functionality.

1.

Applicable to the 82546GB/EB only.

31:0

IPv4 Address

The initial value of IPv4 Address Table entry 0. (IP4AT[0]).
Refer to the EEPROM Address Map listed in 

 for an indication 

of how the bytes are stored.

127:0

IPv6 Address

The initial value of IPv6 Address Table entry 0. (IP6AT[0])
Refer to the EEPROM Address Map listed in 

 for an indication 

of how the bytes are stored.

2.

Not applicable to the 82544GC/EI.