Panasonic AG-HMR10P User Manual

Recording

When the screen below appears, set the

time code value.
Press

to select the time code value.

Press to move to the next digit, and then
press

again to select the value.

Hour

Minute

Second

Frame

Example: To set 10 hours, 23 minutes, 46

seconds, frame 20, select the time code
value “10h23m46s20f.”

Press the [USER] button while setting the time
code to reset the time code to zero.

Press the [ENTER] button when you have

finished setting the time code.

Press

to move to [YES], and then press

the [ENTER] button.

With this portable recorder, the time code value is
adjusted in accordance with the recording format
and frame rate. When shooting is performed with
the recording format set to 1080/24P or 720/24P,
recording is performed 4 frames at a time. For
this reason, if you change the recording format or
frame rate, it may result in discontinuity from the
last time code value of the previous recording.
(Only when [SYSTEM FREQ] is set to [59.9Hz])

Setting the time code

In the [TC/UB SETUP] setup menu, set the
following time code related items. (Page 86)

TC MODE

•

(Only when [SYSTEM FREQ] is set to [59.9Hz])
TCG

•

SDI REGEN

•

TC PRESET

•

When [SDI REGEN] is set to [ON],
the [TC MODE], [TCG] and [TC PRESET]
settings cannot be changed.

Specifying the time code

(TC PRESET)

Set [TC PRESET] to record a value of your choice
as the initial time code setting to be used at the
start of recording.

Press the portable recorder’s [POWER]

button for 2 seconds or longer to turn on
the power.

Press the [MENU] button.

Using the setup menus (Page 29)

Select [TC/UB SETUP] → [TC PRESET].

Press to move to [YES], and then press

the [ENTER] button.

Setting the time code