Panasonic AG-HMR10P User Manual

42

■

   Emphasizing the outlines of the images you 

see on the LCD makes it easier to focus. 
Emphasizing the outlines does not affect the 
images you record.
When this is set, the “LCD DTL ON” message 
is displayed in the middle of the screen. (CAM 
mode only)
Press the [USER] button again to cancel.

 • 

 This function is not canceled even when the 
power is turned off.

 • 

 When the [USER] button is used to switch 
between performing and canceling this 
function, the [LCD DTL] setting in the 
[DISPLAY SETUP] setup menu is also 
switched.

■

   While the [USER] button is pressed, viewing 

angles and video images can be verified by 
reversing the images displayed on the LCD 
monitor horizontally and vertically. 

   The recorded images are not affected when the 

images are reversed on the screen.

 • 

 The normal display is shown when the [USER] 
button is not pressed.

■

   This function allows you to add an index at a 

certain point of a clip during recording. 

   Press the [USER] button during recording or 

shooting. “INDEX” is displayed on the screen 
and an index signal is recorded at that point.

 • 

 To add an index during playback, select 
[INDEX] → [YES] from the [OPERATION] 
setup menu. (Pages 64, 91)

 • 

  If an index cannot be added, “INVALID” is 
displayed.

 • 

  Added indexes can be deleted in PB mode. 
(Page 64)

 • 

 

Up to 100 indexes can be recorded for one 
clip.

 • 

 

When the number of indexes exceeds 100, 
“INVALID” is displayed, and no further indexes 
can be added even when the steps for adding 
indexes are taken.

 • 

 

When repeatedly adding indexes, leave a gap 
of at least one second between adding one 
index and the next. If indexes are added with 
a gap of less than one second between them, 
only the first operation will be valid.

■

   The marks added to clip thumbnails are called 

shot marks. In the thumbnail screen, only clips 
with a shot mark can be selected for display or 
playback.
Press the [USER] button during recording or 
shooting. “MARK ON” is displayed on the LCD 
monitor screen and a shot mark is set for the 
thumbnail of the clip being recorded. Press the 
button again to cancel. 
You can also set or cancel shot marks in the 
thumbnail screen of PB mode. However, note 
that you cannot set or cancel shot marks during 
playback.

 • 

  If shot marks cannot be set or canceled, 
“INVALID” is displayed.

■

   Deletes the last clip that was recorded or shot.
   When the [USER] button is pressed during 

recording or shooting standby, the “DELETE 
LAST CLIP?” message is displayed on the LCD 
monitor screen. Select [YES] to delete the last 
clip that was recorded or shot.
If you do not want to delete the clip, select [NO].

 • 

  If one of the following operations is performed 
after finishing recording or shooting, the last 
clip cannot be deleted even if the [USER] 
button is pressed.

    •  Mode is changed to PB mode
    •  Recording format is changed
    •  Portable recorder’s power is turned off and 

back on again

    •  SD Memory Card is removed