Pelco ccc4000pckit User Manual

Pelco Manual C1931M (5/99)

3

Version 1.2 of the CCC4000 Camera Control software lets you program controls in all mod-
els of the CCC4000 Series color cameras for the following:

•

White balance

•

Vertical phase (V-phase)

•

Edge enhancement

•

Illumination control

•

Hue

These controls determine the way the camera operates by creating unique camera perfor-
mance for special applications.

To set the camera’s controls, the camera is connected to a PC and programmed through a
Microsoft

®

 Windows

®

 interface. You can program and store three sets of settings in the

camera’s memory. In addition, you can recall and use the default factory setting at any time.

The following are minimum hardware and software requirements to run Version 1.2 of the
CCC4000 Camera Control software:

•

IBM-compatible personal computer with available serial interface port

•

Microsoft

 

Windows

 

operating system, Version 3.1 or later

To install the camera control software:

1.

Insert the disk in drive A.

2.

Do one of the following:

If you are installing the CCC4000 Camera Control software under Windows 3.1, select

, and then select drive A.

or

If you are installing the CCC4000 Camera Control software under Windows 95 or a
later version, open 

, and then select drive A.

3.

Double-click 

.

The following screen appears:

The camera control software is automatically installed in the 

 directory on drive

C. If you do not want to install the camera control software in this directory, select a dif-
ferent directory. However, Pelco recommends that you install the software in a sepa-
rate, unique directory.

INSTALL - WHAT

Auto