Combi 8100 User Manual
33
Tighten lower anchor belt to secure the car seat.
Press down in center of car seat to depress
the vehicle cushion and pull free end of lower
anchor belt to tighten belt (fig. f).
the vehicle cushion and pull free end of lower
anchor belt to tighten belt (fig. f).
Check for secure installation. Gripping car seat
at top of armrest, pull car seat front to back and
left to right to check for secure installation (fig. g).
LATCH belt MUST stay tight.
at top of armrest, pull car seat front to back and
left to right to check for secure installation (fig. g).
LATCH belt MUST stay tight.
If LATCH belt does not stay tight or car seat
can not be securely installed, try a different
LATCH location or use the vehicle’s seat belt
to secure the car seat.
can not be securely installed, try a different
LATCH location or use the vehicle’s seat belt
to secure the car seat.
Attach top tether hook (A) to vehicle top
tether anchor hardware (B) (fig. h) and
pull strap to tighten top tether removing
any slack.
tether anchor hardware (B) (fig. h) and
pull strap to tighten top tether removing
any slack.
If top tether anchor (B) is not available in
vehicle, see vehicle owner’s manual or Top
Tether Information in “Selecting A Vehicle
Seating Location” section.
vehicle, see vehicle owner’s manual or Top
Tether Information in “Selecting A Vehicle
Seating Location” section.
10
12
(fig. g)
(B)
(A)
Pull to
tighten
(fig. h)
11
(fig. f)
34
Removal Of Car Seat Installed With LATCH:
Tip belt adjuster to loosen top tether strap
(fig. i).
(fig. i).
Depress retainer spring and unhook
tether hook from vehicle top tether anchor
(fig. j).
tether hook from vehicle top tether anchor
(fig. j).
Loosen lower anchor belt by depressing belt
adjuster slide button and pulling out lower
anchor belt.
anchor belt.
- Pressing down in center of car seat to
reduce tension on lower anchor belt will
make it easier to loosen lower anchor belt.
make it easier to loosen lower anchor belt.
Remove hook-on connectors.
- Press and hold the connector retainer spring .
- Push connector in, then rotate connector ,
and pull out to unhook from the vehicle
anchor (fig. k). If the connector can’t be
rotated, push in and lift the connector to
unhook from the vehicle anchor.
anchor (fig. k). If the connector can’t be
rotated, push in and lift the connector to
unhook from the vehicle anchor.
- Repeat to remove hook-on connector on
opposite side.
(fig. i)
1
1
2
2
Belt
Adjuster
Tether
Hook
Retainer
Spring
1
2
3
1
2
3
4
(fig. j)
(fig. k)
2
1
3