Uniden UBR243 User Manual

9

1.  Place the monitor in a location with clear reception from your camera(s).
2.  If you are using the monitor as a stand-alone unit, flip out the stand on the back of the monitor 

and extend the antenna. Connect an AC adapter to the power input on the side of the receiver.  
If you are using the monitor in the cradle, insert it into the cradle and connect an AC adapter to 
the input jack on the back of the cradle.

3.  Plug the power plug into a 120 volt AC (standard indoor) power outlet or surge protector.
4.  Press and hold the power button to turn the unit on or off.  Let the monitor charge for 6 hours 

prior to first time use so the built-in rechargeable monitor battery is fully charged. DO NOT 
remove the power cable from the monitor/cradle during the initial charge process. After the 
initial charge, recharge the monitor as needed.

5.  Out of range displays until you turn on the camera.

The UBR243 camera and mounting clip are a complete unit. The UBR243 camera  does come with a 
separate suction cup bar. With it installed, you can mount the camera on glass or smooth metallic 
surfaces. 

 

•

The camera included with your monitor is NOT weatherproof; it is an indoor camera.  

 

•

The clearest line-of-sight between the camera and monitor is best. Walls, especially brick and 
concrete, can affect reception quality.

 

•

Avoid having a direct light source in view of the camera (ceiling or floor lamps). 

 

•

Carefully plan where and how the camera will be positioned, and where you will route the cable 
that connects the camera to the power adapter.